brought to you by: Dave Williams
This page: www.bacomatic.org/~dw/fordv8/flathead/flathead.htm
Main page: http://www.bacomatic.org/~dw/index.htm
Last Updated: 18 Sep 2003
Author: Dave Williams; dlwilliams=aristotle=net
All the parts you need to make a flathead Ford V8. This is an early engine
with the split valve guides.
Flathead Ford valvetrain. The large-diameter guides are removeable. This is
an oversize racing valve without the flared tip and an aftermarket adjustable
lifter.
This is Stuart Hilborn's first production Hilborn fuel injection setup.
Four Stromberg two-barrels feed this pretty street rod engine.
Machinist setting up to bore a flathead block. This one has been ported and
relieved.
Stroker kit for the flathead, circa 1959. Stroked crank, high-pin pistons,
rebuilt rods, and new rings and bearings. This kit uses the floating rod
bearings.