Nice Ride Thomas !

Thx Jeremy , you are a live saver !

You know, I always forget the Cruise O Matic has a removable bell housing.  It’s possible it might work with a bell housing swap.

Let me research this a bit and see if I can find a definitive answer.

Can you confirm that every cruise o matic would fit my belhouse ?
And then would fit my lincoln ( only need to rebuild the transmission so it have havy duty parts in it ? )

I look everywhere to find a descend steering wheel, with no luck.
So had to find a solution and I’m very happy with the results.
As the Lincoln logo inside was completely broken and it looks very bad.

As you can see the steering wheel had his best days 40 years ago

The result with some cycle terrorist tape;-)

Just to keep up the suspense some other work that needed attention ( CHROME ) and loads of it !

Befor

After

And id did aboud 1000 bolds and nuts all by hand.

The moment i been waiting for Paint boot time !!

Lets make a Choise

Nice , keep on !

Nice !! no update ?

As always jumping from on thin to the other . maybe not everyone cup of tea
But I like my ride low very low
So I got myself some lowering blocks that was my first mistake as they don’t fit a Lincoln

So I hade to make some myself.

I model it from a original plate that was under the leaf springs

As always jumping from on thin to the other . maybe not everyone cup of tea
But I like my ride low very low
So I got myself some lowering blocks that was my first mistake as they don’t fit a Lincoln

So I hade to make some myself.

I model it from a original plate that was under the leaf springs

As always jumping from on thin to the other . maybe not everyone cup of tea
But I like my ride low very low
So I got myself some lowering blocks that was my first mistake as they don’t fit a Lincoln

So I hade to make some myself.

I model it from a original plate that was under the leaf springs

As always jumping from on thin to the other . maybe not everyone cup of tea
But I like my ride low very low
So I got myself some lowering blocks that was my first mistake as they don’t fit a Lincoln

So I hade to make some myself.

I model it from a original plate that was under the leaf springs

As I had to rip out everting and don’t like do half work, I decided to tackle everything.
Interior , electrics ………………..

Electrics all new cabel back to front and front to back ………….

Loads of sheet metal later , it was time to protect what I rebuild.
all welding haze been covered with melted thin.
I think I did a good job cause I only had to use 2kg of bondo on it and 50% hade to be sanded of again.

THX Jason, car is already finished.
And as you say i did enjoy it , for now it is waiting for me to find a new transmission.
But I’m far from there with my pictures 😉
The only option when you see rust and rot is to replace it .

Welcome to the site, Thomas!