Updates: Bumper brackets picked up. Many they LOOK killer! My guy did them in a matte finish, which I really like. Hoping to get the transmission in this weekend to get the starter mounted and finish the wiring real soon. Also, took the car to Scrapin’ The Coast in Bilouxi and had a killer time. 4 confirmed slabs there and one more cruising around…[Read more]

But here are the updated pics:

Better pics of the new p/s lines:

#Mobsteel – they also have an new website and finally gear you can purcahse.

Lastly, I’m doing a new Podcast with my good friend Mike Murray. The title of it is Our Lifestyle. We are going to bake in a good bit of Lincoln / Slab talk. Please check out…[Read more]

Did some work on the Lincoln yesterday after getting home from traveling this week at work.

I used a Ron Francis Wiring stud and placed it near the wiring harness. This will be used for the stereo power wire etc. I ran the power to it for the ViAir compressors and AccuAir air mgmt system.

Pretty much finalized the AccuAir wiring…[Read more]

So I’ve been collecting more parts and steady working on the car as much as I can. Last Saturday I hit The Lincoln Ranch (Lincoln-Ranch.com) to meet up with Tim. I was in need of a driveshaft (mine has big dents in it) and misc other items. I got the parts I needed and had the driveshaft installed a few hours later after getting home. I jacked it…[Read more]

Thanks man! Updates:

I did some work to clean up the wiring behind the dash I had ran previously. I tend to leave too much excess “just in case” which is always too much.

Hit the pedal setup with a wire brush and with black paint.

Before:

After:

Upcoming:

Thanks man! Updates:

Thanks man. Good lookin out. I have a fuse on the compressors / AccuAir out back but will keep that in mind for other stuff I plan to run to the stud.

I did some work today to clean up the wiring behind the dash I had ran previously. I tend to leave too much excess “just in case” which is always too much.

Forgot to…[Read more]

Bad ass project!

Bad ass man. Can’t wait to see it come together. Good chilling’ with you yesterday in Lakeland.

I’m looking forward to following this bad ass build!

Ryan, there are front sump pans available for the Cummins diesel. It wouldn’t be much of a problem to change out the pick up tube and pan. Though if you plan to change out the entire front suspension and crossmember than you can make anything fit.

EDIT : Apparently the pan itself can be reversed, but you’ll need the appropriate front sump pickup…[Read more]